2.After installing Master Radio Unit mounting hardware, connect the Dual Radio Cable Connector (P3) to the Master Radio Unit. Tighten the two jackscrews on P3.
3.Next route the Remote Control Cable (19B802554P3 or P4) between Control Head and Master Radio locations. After installing Control Head, connect Remote Control Cable Connector (P2) to Control Head.
4.Connect "IGN A+" lead, if option is desired. Be sure internal Switch SW601 on Master Radio is set properly. Refer to Page 20 of this manual for details.
5.Connect Accessory Cable (19B802554P6 or P7) Connector (P1) to Control Head.
6.Connect Microphone and Accessories. Refer to Accessory Installation Manual for proper connection of Accessories.
7.Now connect Remote Control Cable Connector (P1) to the Dual Radio Cable Connector (P2), and tighten to jackscrews on P2.
8.Connect Power Cable, and Antenna, then install Master Radio Unit in mounting bracket.
9.After installing Slave Radio Unit in its mounting hardware, connect Dual Radio Cable (P1), and tighten jackscrews. Be sure SW601 setting on Slave Radio Unit is same as for Master Radio Unit. Connect Power Cable and Antenna to Slave Radio.
10.Check Dual Radio operation, using operator's manual as test guide.
45
