Installation

Charging the battery

Place the cordless phone in the charger as shown in the figure below.

The battery is being charged when the lower green LED (Light Emitting Diode) on the charger is on (and the battery meter on the display flashes). If the battery is completely empty it can take a few minutes before the lower green LED on the charger is lit.

When the battery is 90% charged, the LED starts flashing (3 second intervals) and when the battery is fully charged, trickle charging starts (LED lights up for 1 second every 30 seconds) and the battery is ready.

Notes:

Place the DT292 in the charger and charge it for at least 4 hours before using it the first time.

Make sure the local mains voltage corresponds to the voltage on the charger.

Only use the charger that is delivered with the cordless phone.

Do not connect the phone to the charger without a battery.

90

DT292

Page 90
Image 90
Ericsson DT292 manual Charging the battery