Eton YB550 operation manual Accessing What is Stored Into Memory

Y B 5 5 0 P E O P E R AT I O N M A N U A L

ACCESSING WHAT IS STORED INTO MEMORY

Below, the three ways to access what has been stored into memory are described: Direct Memory Access, Memory Search and Memory Autoscan. When the memory page and memory preset numbers appear in the upper right corner of the dis- play, as it will in the sections below, the radio is in MEMORY ACCESS MODE. This mode can be exited any time with a press/release of the M.Scan/Page button.

DIRECT MEMORY ACCESS: To directly access a memory pre- set, the page number and preset number must be entered, as shown below:

1.Press/hold the M.Scan/Page button for about 3 seconds.Then release it. Note that the memory page is flashing in the upper right corner of the display.

2.Within 5 seconds select the desired page with the + and

– buttons.

3.Within 5 seconds, use the numeric keypad to key-in the memory preset number that you wish to access. (if it is under 10, key in 01, 02, etc.). NOTE: Once a page number has been selected or changed, even if it is not seen on the screen, a memory preset on that page can be selected by keying in the memory number with the numeric keypad, without having to re-do steps 1 and 2 above.

MEMORY

MEMORY SEARCH: Memory Search enables searching through the memory presets within a memory page, as shown below:

1.Press/release the M.Scan/Page button.

2.Use quick, short presses on the + or – buttons to search through the memory presets.

MEMORY AUTOSCAN: Memory Autoscan enables scanning through the memory presets within a memory page. The memory being scanned enables listening to the station for about 5 seconds and will then move on to the next memory automatically. Autoscan will continue indefinitely on the selected page until deliberately stopped.

1.Press/release the M.Scan/Page button.

2.Press/hold either the + or – button for about 3 seconds. Then release it. Note that the memory preset number in the upper right corner of the display flashes and the pre- set being scanned remains for about 5 seconds. It then moves on to the next memory preset for another 5 sec- onds. To stop memory preset autoscan, press/release either the + or – button.

34 35