6.2.13Steering Chain Adjustment
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Position the steering handle bar so that it points the unit straight forward (the rear steering wheel should be in line with the rider main frame channel).
c)Check to see if the chains are loose.
d)To take up slack in the chains, loosen the rear jam nuts connecting the eyebolts to cross link bars, then equally tighten each forward jam nut until slack is taken up. Retighten the forward jam nuts onto the links.
e)If the unit tends to turn left when handle bar is positioned for straight forward travel, adjust by shortening the right hand link (threading jam nuts closer to “eye” end of the eyebolt) and lengthening the left hand link (threading jam nuts away from the “eye” end of the eyebolt) an equal amount. Re check chain tension.
f)If the unit tends to turn right when handle bar is positioned for straight forward travel, reverse procedure as stated in paragraph “d” above.
6.2.14Throttle Control Adjustment
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Loosen the cable clamp on the engine and position the throttle control at the control console within 1/4” (6mm) from the upper end of the slot. Pull on cable assembly at lower end, where it attached to the engine, until the throttle control arm contacts the stop screw. Secure cable with cable clamp.
6.2.15Throttle Cable Tension
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Tension in throttle lever can be adjusted by adjusting the tightness of the lever pivot bolt, which is located under the console. See Figure 15.
FIGURE 15
THROTTLE TENSION
6.2.16Seat armrest adjustment.
a)Lift armrest on seat. Locate square tab marked with the numbers 1 through 4. Rotate square tab 1/4 turn to raise or lower the armrest in approximately 1/4” increments. See Figure 16.
Armrest Adjustment Tab
Rotate ¼ Turn
FIGURE 16
ARMREST ADJUSTMENT
- 33 -
