5.1.13Check hydraulic oil level:
Service Interval: 40 hr.
a)Stop engine and wait for all moving parts to stop.
b)Clean area around hydraulic reservoir cap and remove cap. Oil level should be to the top of the baffle inside the tank. If not, add oil. Use only Mobil 1
NOTE: The baffle has two levels. The upper level represents the “HOT” level and the lower level represents the “COLD” level. The oil level varies with the temperature of the oil. The “HOT” level shows the level of oil when it is a 225°F (107°C). The “COLD” level shows the level of the oil when it is at 75°F (24°C). Fill to the appropriate level depending upon the temperature of the oil. For example: If the oil is about 150°F (65°C), fill to halfway between the “HOT” and “COLD” levels. If the oil is at room temperature (about 75°F (24°C)), fill only to the “COLD” level.
5.1.14Check tire pressures:
Service Interval: 40 hrs.
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Check tire pressure in drive tires.
c)Inflate drive tires to 10 psi (69 kPa).
d)Caster tires do not need to be inflated.
NOTE: Do not add any type of tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires may cause failures to the hydro drive system, frame, and other components. Foam filling tires will void the warranty.
5.1.15Check condition of belts:
Service Interval: 40 hrs.
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Tilt seat up. Lift the rubber flaps on front side of the engine to check pump drive belt and alternator drive belt.
c)Remove left and right belt shields on deck and lift up floor pan to inspect deck drive belt.
d)Remove bumper and check under machine to inspect the two mule drive belts and fan pump drive belt.
e)See Sections 5.2.3, through 5.2.7 for belt adjustments.
5.1.16Lubricate grease fittings:
Service Interval: Refer to chart.
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Lubricate fittings with one to two pumps of NGLI grade #2
- 32 -
