Exmark Lazer Z XP Swivel Adjustment, Front of Unit, Spring Compression Adjustment, 11 1/2”, G0122

b)Stop engine, wait for all moving parts to stop, and remove key.

c)Check tire pressure of drive tires. If needed, adjust to 10 psi (69 kPa). Semi-pneumatic caster tires do not need to be inflated.

d)Set anti-scalp rollers to top holes or remove them completely for this adjustment.

e)Raise the deck to the 5” height position (also transport position) and take all force off of the two large deck lift springs by loosening the nuts at the front of each spring. See Figure 13.

f)Lower the deck to the 1-1/2” height position. Force the left rear deck support arm downward about 1/4” to get the deck to rest at the 1-1/2” height position. Place locking pliers between the rear swivel and spring stop to hold the deck in this position. See Figure 13.

g)Place a 3/4” thick block of wood under each of the two (2) rear anti- scalp roller brackets and place one under one of the front center anti-scalp roller brackets.

h)Loosen the two (2) top chain bolts in slots in the rear deck lift arms. Loosen jam nuts and back off the socket head adjusting screws on the bottom of the arms until the chains are just loose. Turn the socket head adjusting screws in until slack is taken out of each chain. Tighten the jam nuts. Tighten the chain bolts in the deck lift arms making sure they don’t move while tightening.

i)Loosen the four (4) nuts which secure the front swivels (two per side) until the front chains are loose and front of deck is supported by the 3/4” block. Do not loosen the front chain hardware.

j)On left side, adjust front swivel using the locking nut behind the swivel until the front chain is tight and all slack is removed from linkage. Do not lift front of deck off 3/4” block. Secure front swivel using locking nut in front of swivel. Repeat for right side.

k)Recheck that the 3/4” blocks fit just snugly under the brackets and that the tension on all the chains are approximately equal. Make sure all chain attachment bolts are tight. Reposition anti-scalp rollers and tighten securely.

Place locking pliers here to hold spring

Apply downward

pressure here

Jam nut

11 1/2”	Remove force on
	deck springs by

loosening nuts here

Swivel

Socket head

adjusting screw

Front of Unit G0122

FIGURE 13

SWIVEL ADJUSTMENT

SPRING COMPRESSION ADJUSTMENT

l)Raise deck lift lever to the 5” cutting height position See Figure 8. Adjust spring compression until proper distance is obtained between the two large washers (See Figure 10). Adjustment is made by turning the nut at the front of each spring (clockwise will shorten the spring, counter-clockwise will lengthen the spring). Lock in position with jam nuts.

NOTE: When above adjustments have been made, the front of the deck will be slightly lower than the rear of the deck.

- 38 -