LUBRICATION CHART
| FITTING | INITIAL | NO. of | SERVICE |
| LOCATIONS | PUMPS | PLACES | INTERVAL |
1. | Front Caster wheel hubs | ∗0 | 2 | ∗Yearly |
2. | Front Caster Pivots | ∗0 | 2 | ∗Yearly |
3. | Height Adj. Shaft Bearings | 1 | 5 | 40 hours |
4. | Deck Drive Belt Idler Arm | 1 | 1 | Yearly |
5. | Brake Brackets | 1 | 2 | 200 hours |
6. | Fan Pump Belt Idler Arm | 1 | 1 | 40 hours |
7. Wheel Drive Pump Belt Idler Arm | 1 | 1 | Yearly | |
8. | Deck Rear Struts | 1 | 2 | 40 hours |
9. | Mule Drive Belt Idler Arms | 1 | 2 | Yearly |
∗See Section 5.1.16 c) for special lubrication instructions on the front caster pivots and Section 5.1.17 for special lubrication instructions on the front casters wheel hubs.
No. 6 (Fan Pump Belt Idler Arm)
Access through hole in bumper plate
No. 7 (Pump Drive Belt Idler Arm)
Located Under Seat
c)Lubricate front caster pivots once a year. Remove hex plug and cap. Thread grease zerk in hole and pump with grease until it oozes out around top bearing. Remove grease zerk and thread plug back in. Place cap back on.
5.1.17Lubricate caster wheel hubs:
Service Interval: Once Yearly
a)Stop engine, wait for all moving parts to stop, and remove key.
b)Remove caster wheel from caster forks.
c)Remove seal guards from the wheel hub.
d)Remove one of the spacer nuts from the axle assembly in the caster wheel. Note that thread locking adhesive has been applied to lock the spacer nuts to the axle. Remove the axle (with the other spacer nut still assembled to it) from the wheel assembly.
e)Pry out seals, and inspect bearings for wear or damage and replace if necessary.
FIGURE 10
CASTER WHEEL ASSEMBLY
f)Pack the bearings with a NGLI grade #1
g)Insert (1) bearing, (1) new seal into the wheel.
NOTE: Seals (Exmark PN
h)If the axle assembly has had both spacer nuts removed (or broken loose), apply a thread locking adhesive to (1) spacer nut and thread onto the axle with the wrench flats facing outward. Do not thread spacer nut all of the way
- 33 -
