INSTALLATIONINSTALLATION
- 7 -
TESTING THE MODEM
This section contains steps to verify the installation of the ThinCom Modem portion by using a communication software.
1. Install and start a data communication software. (for Microsoft Windows users Click on Accessories Group => Terminal) Select terminal mode.
2. In setup modem, set COM port to match COM Port previously set by the PC Card device driver
3. Set Baud Rate, Data bits, Parity, Flow Control and Stop bit parameters to your normally use.
4. Enter the terminal mode. This will allow you to issue the 'AT' command directly to the modem.
5. Type 'AT' or 'at' then press ENTER key. (Note: the modem will not recognize mixed case such as 'At' or 'aT') The modem should respond with 'OK' on the screen. The modem=s active parameters
may be reviewed by using the AT&V command.
TESTING THE NETWORK
On the next system reboot the EXPNET.BAT file will start and attempt to log in to a network.
The THINCOM.EXE PC Card network adapter driver