Function Range | EXP Computer PCMCIA Ethernet Modem Adapter specs

						APPENDIX B


	S13	Reserved	-	-	-
	S14	General Bit Mapped Options	-	-	*		138 (8Ah)
	S15	Reserved	-	-	-		-
	S16	Test Mode Bit Mapped	-	-			0
		Options(&T)
	S17	Reserved	-	-			-
	S18	Test Timer	0-225	s	*		0
	S19	AutoSync Bit-Mapped Options	-	-	-		-
	S20	HDLC address or BSC sync	0-255	ASCII	-		-
		character
	S21	V.24/General Bit Mapped	-	-	-		4(04h)
		Options
	S22	Speaker/Results Bit Mapped	-	-	*		117(75h)
		Options
	S23	General Bit Mapped Options		-	*		55(37h)

	S24	Sleep Inactivity Timer	0-255	s			0
	S25	Delay to DTR Off	0-255	s or			5
				0.01s
	S26	RTS-to-CTS Delay	0-255	0.01s			1
	S27	General Bit Mapped Option	-	-	*		73(49h) w/ ECC
							74(4Ah)w/o ECC
	S28	General Bit-Mapped Options	-	-	*		0
	S29	Flash Dial Modifier Time	0-255	10 ms			0
	S30	Disconnect Inactivity Timer	0-255	10s			0
	S31	General Bit-Mapped Options	-	-	*		2

	S32	XON Character	0-255	ASCII			17 (11h)

	Register	Function	Range	Units	Save		Default

- 39 -

Image 43

EXP Computer PCMCIA Ethernet Modem Adapter user manual Function Range

Contents

ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement Introduction Introduction Hardware Installation Guide Installation Installation Network Environment Driver selection Installation Verification Installation Testing the Network Installation Testing the Modem Install the Thincom Card Windows 95 InstallationIf Something Goes Wrong Enabling 32-BIT Card Support in Windows Modem Installation Verification Network Installation Data Communication Operation Operating Mode Operating Mode Cellular Operation Remote AccessData Communication File Transferring FAX Operation FAX OperationPage Diagnostic Function Diagnostic Troubleshooting TroubleshootingNo Dial Tone Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 Commands Caller ID Commands Enable MNP 10 extended services detection only Cellular Commands Command Default Function Basic AT= command for 1414 CL Disabled QAM modulation only Is enabled when DTR is turned onConfigured. DTR option Hz guard tone enabled Range No Retrain ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function S37000 S90000 S108002 S109062 Enable Bps rate adjusting Dial Modifiers Command Function Disables V.42 bisEnables V.42 bis only when transmitting data Enables V.42 bis only when receiving data Command Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range Units Function Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance Statements FCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page