VN-Matrix 300 • System Conguration 30
Device Setup (c)
The Device setup area allows a VN-Matrix 300 device to be congured as either an
encoder or as a decoder.
NOTE: The VN-Matrix 300 is available as a decoder (VND 300) only. In this case it is not
possible to configure the unit as an encoder.
Create Source (Encoder)
Select this option to create a source (ENCODER).
zSource will be shown adjacent to a change device type button.
zA videoport and ancport icon will be created in the Configuration window.
Figure 17. Source (Encoder) Configuration and Setup
The Device Setup area provides access to the following controls and information.
zMode:
z Enable — Normal operation; image transport is enabled.
z Disable — Image transport is disabled.
z Standby — Same as disable.
zIdentify — When checked, causes the name of the device to be overlaid on the content
that is presented on the SDI-OUT connector on the rear panel.
zData Interface — The selection defines which of the two network interfaces is to be
used for the data transport.
zMulticast TTL — This value sets the Time To Live (TTL) for multicast packets.
Configuration (d)
The Configuration area provides access to the device configuration pages.
zClick on an icon to access the configuration pages.