VN-Matrix 300 • Alarms and SNMP 59
Alarms and SNMP
This section provide the following:
zOverview — Alarms
zAlarms Page
zOverview — SNMP
zSNMP Trap Destinations

Overview — Alarms

The VN-Matrix 300 is congured to generate alarms for range of error conditions. A list of
these error conditions and their meanings are presented on the following pages.
Alarms can be monitored at a number of locations throughout the WEB GUI:
zAlarms page
In the list immediately below the Filter Settings box. This details the alarm
conditions that are currently active on the system.
zAlarm Logs page
In the list immediately below the Filter Settings box. This provides a historical log of
when an alarm condition was raised and cleared.
zDevice list page (see figure 15)
Where a Trafc light symbol in the Status Column is used to represent the status of a
device.
zIn the top right hand corner of each page in the GUI.
Where the device status and system status is displayed.
In addition the red LED located on the front panel of the VN-Matrix 300 illuminates
whenever a critical alarm is triggered.
Alarm conditions, once triggered, will be remain active until the error that caused it has
cleared and then for a further 5 seconds.