Installation, cont’d

PRELIMINARY

Cable Clamp

Metal Wall Box

Screw

Braided Shield

Install Cable

Foil Shield

Grounding outer braided and foil shields

WTo prevent short circuits, the outer foil shield can be cut back to the point where the cable exits the cable clamp. Both braided and foil shields should be connected to an equipment ground at the other end of the cable.

7. Insert the wall box into the opening, and attach it to the wall, stud, or furniture.

•For the Extender WM, Extender WM AAP, Extender WM AUS, Extender D, and the Extender AAP or Extender AAP EX (if installed in a two- or four-gang AAP plate), attach the wall box to the wall stud or furniture with nails or screws, leaving the front edge flush with the outer wall or furniture surface. See the following illustration, which applies to one-, two-, three-, and four-gang wall boxes.

Wall Stud	Wall Stud
Installation Cable	Installation Cable
Cable Clamp	Cable Clamp

Screws or Nails

Attaching a wall box to a wall stud

Extron electronic Extender Series manual Installation, cont’d, Preliminary

Models: Extender Series