Extron electronic manual Quick Start Guide - Extender Series, Step

Quick Start Guide — Extender Series

WInstallation and service must be performed by authorized personnel only. These products must be used with UL approved, grounded electrical boxes.

Step 1

Turn all of the equipment off and disconnect the power cords from the power source.

Step 2

Select the installation location and install the electrical wall box. See “Preparing the site and installing the wall box” in chapter 2.

NThe Extender AAP EX does not require a wall box because it will be installed into an Extron HSA 400 Series or HSA 800 Series surface access product.

Wall Stud

Installation

Cable

Cable Clamp

Screws or

Nails

Step 3

Attach the cables. See pages 2‑6, 2-7, and

2‑9. For the Extender AAP EX, install the unit into the faceplate of an Extron HSA 400 Series or HSA 800 Series surface access product before attaching the cables.

To RGB

Video Equipment

Sleeve (s)

Left Ring

Left Tip

Power

9-18 VDC

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground contact. DO NOT connect the sleeve(s) to the negative (-) contacts.

	R	NO Ground Here
	Audio	Right Tip
		Sleeve(s)
	L	NO Ground Here
		Left Tip
Power		Audio
	Unbalanced Output
9-18 VDC		Right Ring
	R
	Audio	Right Tip
		Sleeve(s)
	L	Left Ring
		Left Tip

Balanced Output

Right Ring

Right Tip

Sleeve (s)

Left Ring

Left Tip

Do not tin the wires!

Extender Series • Quick Start Guide QS-1