Extron electronic Extender Series UL Requirements, Installation Instructions, Preliminary

Installation

PRELIMINARY

CInstallation and service must be performed by authorized personnel only. This product should be used with a UL approved electrical box. See “UL Requirements”, below.

UL Requirements

1.The Extender must be installed in an Underwriters Laboratories (UL) listed junction box. The UL approved electrical wall box (junction box) is not included with the unit; the installer is responsible for obtaining and installing the box.

2.The unit must be installed with accordance with the National Electrical Code and with local electrical codes.

Installation Instructions

All of the Extenders can be mounted into furniture, a wall, an Ackermann floorbox, or an Extron HSA 400 Series or HSA 800 Series enclosure (depending on the model).

For Extender AKM UK AAP mounting instructions, refer to the AKM UK Series Installation Guide (part number 68-904-01).

For Extender AKM MAAP mounting instructions, refer to the AKM MAAP Installation Guide (part number 68-1031-01).

CThe Extender must be installed into an Underwriters Laboratories (UL) approved electrical wall box. The box is not included with the Extender; the installer is responsible for obtaining and installing the box.

For Extender AAP EX mounting instructions, refer to the user’s manual or installation manual for the appropriate model of HSA Hideaway Surface Access enclosure.

NThe Extender AAP EX does not require a wall box because it will be installed into an Extron HSA 400 Series or HSA 800 Series surface access product.

Preparing the Site and Installing the Wall Box

Choose a location that allows cable runs without interference. Allow enough depth for both the wall box and the cables. You may need to install the cables into the wall, furniture, or conduits before installing the line driver.

•The Extender AAP or Extender AAP EX can be installed in an Extron two-gang,four-gang, or half rack width AAP Architectural Adapter Plate or in the faceplate of another Extron device that accepts AAP plates, such as an interface or distribution amplifier. Refer to the mounting instructions for the adapter plate or device.

2-2 Extender Series • Installation