Extron electronic Extender Series manual Extender WM is shown here wired for balanced

CAUTION
For unbalanced audio, connect the
sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the
negative (-) contacts.		NO Ground Here
	R
		Right Tip
	Audio
		Sleeve(s)
	L	NO Ground Here
		Left Tip
Power		Audio
9-18 VDC	Unbalanced Output
	R	Right Ring
		Right Tip
	Audio
		Sleeve(s)
	L	Left Ring
		Left Tip

Balanced Output

Right Ring

Right Tip

Sleeve (s)

Left Ring

Left Tip

Do not tin the wires!

PRELIMINARY

	Extender WM is shown here wired for balanced
	audio output; the circuit board configuration is the same
	for the Extender WM AAP and the Extender D
B	RGB video output connectors — Attach coaxial cables from the
	Extender to the display device via these female BNC connectors.
	These BNCs are on pigtail wires secured to the Extender by tie
	wrap.

C Power connector —

+ or –	rPowe 9-C18VD
– or +

Do not tin the wires!

Connect a 9 VDC to 18 VDC power supply to this 3.5 mm, 2-pole direct insertion captive screw connector. Wire the connector as shown here. Polarity is not important.

CFor best results and to reduce the risk of short circuits, trim just 3/16” (5 mm) of the jacket from the wires. Do not tin the wires.

Extender Series • Installation 2-11