Extron electronic HSA 200SE Installation, cont’d, Extron HSA, Hideaway Surface Access Enclosure

Installation, cont’d

Preparing the table with a hole saw (HSA 200C, HSA 200CE, or HSA 222C—US version only)

1.	Locate the desired mounting location on the tabletop or
	other installation surface. Mark the 6" circle, then find the
	center and mark it as well.
		Wear safety glasses when operating the hole saw.
		Failure to comply can result in eye injury.
2.	Using a 6" hole saw on a portable drill, cut the mounting
	hole at the desired location (figure 2-3). Extron is not
	responsible for improperly positioned HSA products.
		Use a portable drill with sufficient power for the 6"
	CAUTION
		hole saw. Exercise caution when handling the drill
		and hole saw. Care should be taken to protect the
		surface of the tabletop, podium, or other mounting
		surface from damage.

2.	Remove the plastic strips that protect the corners of the
	enclosure. If a sticky residue remains, remove it with an
	appropriate metal cleaning product.
		Do not use isopropyl alcohol or other solvents to clean
	CAUTION
		the HSA. Strong solvents will ruin some finishes.
3.	Carefully lower the HSA enclosure into the hole to test the
	fit. If necessary, remove the enclosure and use a file or
	rasp to enlarge or smooth the edges of the opening.
4.	From the underside of the table, reinstall the screw clamps
	on the enclosure at a height at which the clamp will reach
	the underside of the tabletop (figure 2-4).

Figure 2-4 shows an HSA 200 installation. Except for the video and audio connectors, the HSA 222 installation is identical.

Figure 2-3 — Cutting the opening with a hole saw

Installing the HSA enclosure (all)

1. Remove the screw clamps (2) on the sides of the enclosure.

CAUTION	The flanged edges of the top of the surface enclosure
	are bevelled to an ultra-fine thickness of less than
	0.04 (4/100)" (approximately 1 mm), and are

Power Cord

2 RJ-45 Connectors

Audio Cable (HSA 200 models only)

Extron

HSA 200

Hideaway Surface

Access Enclosure

Output BNC

Connectors

(HSA 200 models only)

Mounting

Surface

Screw Clamp

Display BNC

Connectors

(HSA 200 models only)

therefore very sharp. These edges are also soft and

may be easily nicked or bent. Exercise caution

when handling and mounting the enclosure.

Mishandling may result in injury to the installer or

damage the appearance of the enclosure.

Figure 2-4 — Mounting the HSA 200 or HSA 222 enclosure

2-6 HSA 200/222 Series • Installation HSA 200/222 Series • Installation 2-7