Extron electronic HSA 200SE, HSA 222C user manual Packaging for Shipment

Packaging for Shipment

The HSA 200’s and HSA 222’s ultra-fine machined surfaces and moving parts make them vulnerable to damage caused by mishandling during shipment, if they are improperly packaged. If, for any reason, you need to return an HSA to Extron, first contact Extron to obtain a return kit. The return kit, which reduces the chances of damage during shipment, includes a sturdy shipping carton and foam shells custom cut to fit the HSA (figure B-1).

Figure B-1 — HSA 200/HSA 222 return kit

Package an HSA for shipment as follows:

1.	Contact the Extron S3 Sales & Technical Support Hotline to
	obtain a return kit. Extron will send the return kit to the
	location you specify.
		The flanged edges of the top of the surface
		enclosure are sharp when the HSA is removed from
		the table. Exercise caution when handling to
		prevent personal injury.
		The flanged edges of the top of the surface
	CAUTION
		enclosure are bevelled to an ultra-fine thickness of
		less than 0.04 (4/100)” (approximately 1 mm).
		These edges are soft and can be easily nicked or

bent. Exercise caution when handling and mounting the enclosure. Mishandling can damage the appearance of the enclosure.

2.	Disconnect all cables and remove the HSA 200 or HSA 222
	from the table or desk. See Removing and Replacing the
	Enclosure, steps 1 through 4, in chapter 3, Maintenance and
	Modifications.
3.	Place the enclosure on a flat, horizontal surface. To protect
	the finish, place it on a soft cloth or rubber mat.
4.	Install the plastic strip (part of the return kit) to protect the
	flanged edges of the top of the enclosure (figure B-2).

Figure B-2 — Installing protective strips

5. Open the top panel and insert the HSA 200 or HSA 222 into the custom cutout portion of one of the foam shells (figure B-3).

Figure B-3 — Installing the HSA into the foam shell

B-2 HSA 200/222 Series • Packaging for Shipment HSA 200/222 Series • Packaging for Shipment B-3