Extron electronic IPL T CR48 Installation and Operation, cont’d, Furniture or projector mounting

Installation and Operation, cont’d

Furniture or projector mounting

In addition to using the IPL T CR48 unit on a rack, it can also be furniture or projector mounted. Furniture mount or projector mount the interface using the optional mounting kit (Extron part #70-212-01, furniture, or Extron part #70-217-01, projector) as follows:

1. Attach the mounting brackets to the interface with the machine screws provided (figure 2-3).

2. If feet were previously installed on the bottom of the interface, remove them.

3. For furniture mounting, hold the interface with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.

4. For furniture mounting, drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the mounting surface at the marked screw locations.

5. For furniture mounting, insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4” of the screw head protrudes.

6. For furniture mounting, align the mounting screws with the slots in the brackets and place the interface against the surface, with the screws through the bracket slots.

7. For furniture mounting, slide the unit slightly forward or back, then tighten all four screws to secure it in place.

8. For projector mounting, secure the interface to a projector mount or other surface by inserting the mounting bolt through the bracket’s slotted hole.

Projector

Lift

Control

Mounting

Bolt

Projector

Projector Mount

IPLT

CR48

R

1INPUT
3	3RELAY
2
1
4	5
2	7
	4	100
	6
	8	LINK
		ACT

Furniture Mount

Projector

Mounting

Bracket

Figure 2-3 — Furniture and projector mounting for the IPL T CR48

2-4 IPL T CR48 • Installation and Operation