Extron electronic user manual Mounting the MP 101 AAP, MP 101 Series MP 101 AAP

level that is free of distortion.

NIf there is a remote control connection, unplug it while adjusting the Mic Gain potentiometer. Replace the remote control when finished.

4.If there is minimal distortion, but greater volume is required, turn the Mic Gain potentiometer clockwise (towards the 75 dB mark) to increase the volume, but not past the point where distortion occurs.

Mounting the MP 101 AAP

The MP 101 AAP must be attached to a device faceplate or AAP wallplate and then cabled before you can test and perform the final mount (installation into a wall or piece of furniture).

NBefore mounting, the MP 101 AAP should be tested to verify that its connections and settings are correct.

To mount the MP 101 AAP into a device faceplate or AAP wallplate, do the following:

1.	Before any cables are attached, insert the MP 101 AAP’s
	standoffs through the holes in the device’s faceplate or
	AAP wallplate.

2.Secure all cables and connections into the rear connectors of the MP 101 AAP.

3.Using the provided #4-40 nuts and captive washers, secure the preamplifier to the faceplate or wallplate, as shown below.

Wall Stud

Screws or Nails

#4-40 Nut w/ Captive Washer

Cable

Clamp

102

AAP

Extron

AAP 102

Installation Cable

ACTIVE
	AAP
	101
MUTE	MLP
MIC
IN

Extron

MP 101 AAP

MIC to Line

Preamplifier

MP 101 Series • MP 101 AAP 3-5