Extron electronic user manual Adjusting the MP, MP 101 Series MP

Models: MP 101

1 47
Download 47 pages 43.86 Kb
Page 17
Image 17
Adjusting the MP 101

b.At each mark, drill a 3/32" (2 mm) diameter pilot hole approximately 0.25" (6 mm) deep in the mounting surface.

c.Insert provided #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 0.25" (6 mm) of the screw protrudes.

d.Align the bracket slots with the wood screws and place the unit against the mounting surface.

e.Slide the unit either forward or backward until the screws are in contact with the edge of the bracket slots. Then, tighten each screw to secure the unit in place.

Adjusting the MP 101

After the MP 101 has been properly mounted and connected, do the following to adjust it:

1.If using a condenser microphone, set the Phantom power switch to the “on” position.

If using a dynamic microphone, set the Phantom power switch to the “off” position.

2.When using the microphone for voice audio, flip the Low Cut switch to “on” to reduce wind and “table rumble” noise.

When using the microphone for music audio, flip the Low Cut switch to “off” to preserve the optimum sound quality.

3.Set the Mic Gain potentiometer by saying a few words into the microphone and adjusting for the maximum sound level that is free of distortion.

NIf there is a remote control connection, unplug it while adjusting the Mic Gain potentiometer. Replace the remote control when finished.

If there is minimal distortion, but greater volume is required, turn the Mic Gain potentiometer clockwise (towards the 75 dB mark) to increase the volume, but not past the point where distortion occurs.

MP 101 Series • MP 101 2-9

Page 17
Image 17
Extron electronic user manual Adjusting the MP, MP 101 Series MP