Extron electronic MP 101 Series MP 101 D, Audio output line level, Remote connection

Models: MP 101

1 47
Download 47 pages 43.86 Kb
Page 28
Image 28
MP 101 Series • MP 101 D 4-3

NDo not tin the stripped power supply leads before installing the captive screw connector. Tinned wires are not as secure in the captive screw connectors and could pull out.

WThe two power cord wires must be kept separate while the power supply is plugged in. Remove power before continuing.

Audio output (line level)

b Phantom power switch — Provides switchable 48 volt phantom power for condenser microphones.

c Line Output — A 3-pin, captive screw connector outputs to audio mixers, amps switchers, or other non-microphone audio equipment.

3/16"

(5 mm) MAX

Captive Screw

Connector stripping

Tip

Ring

Sleeve

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground. DO NOT connect the sleeve(s) to the negative (-) contact.

Tip

NO Ground Here

Sleeve

d Low Cut filter switch — Provides low cut filtering to remove wind and “table rumble” noise.

Remote connection

e Remote — An optional 3-pin, captive screw connector allows a wall mounted audio controller or MediaLink product to remotely control volume and mute levels for the MP 101 unit. See “Remote Control”, later in this chapter, for more information.

MP 101 Series • MP 101 D 4-3

Page 28
Image 28
Extron electronic user manual MP 101 Series MP 101 D, Audio output line level, Remote connection