Extron electronic MP 101, cont’d, Front Panel Features, Remote connection, 2-4MP 101 Series MP

MP 101, cont’d

Remote connection

d Remote — An optional 3-pin, captive screw connector allows a wall mounted audio controller or MediaLink product to remotely control volume and mute levels for the MP 101 unit. See “Remote Control”, later in this chapter, for more information.

Audio output (line level)

e Line Output — A 3-pin, captive screw connector outputs to audio mixers, amps switchers, or other non-microphone audio equipment.

3/16"

(5 mm) MAX

Captive Screw

Connector stripping

Tip

Ring

Sleeve

CAUTION

For unbalanced audio, connect the sleeve(s) to the ground. DO NOT connect the sleeve(s) to the negative (-) contact.

Tip

NO Ground Here

Sleeve

Balanced Output	Unbalanced Output
	(high impedance)

Front Panel Features

a b

MIC GAIN

(dB)	LOW CUT PHANTOM
	ON

	25	72	OFF
			MP 101
1	2	3	4

Power LED — This LED lights green to indicate that the unit is receiving power.

Mic Gain — A recessed, adjustable potentiometer defines the amount of input signal (between 25 and 72 dB) allowed into the preamp.

c d

Low Cut filter switch — Provides switchable low cut filtering to remove wind and “table rumble” noise.

Phantom power switch — Provides switchable 48 volt phantom power for condenser microphones.

2-4 MP 101 Series • MP 101