Extron electronic MVX 88 Installationstallation, cont’d, Mounting the Switcher, Tabletop use

Installationstallation, cont’d

Mounting the Switcher

Keep the switcher out of bright light to prevent interference with the IR signals from the IR 501 remote control.

Tabletop use

For tabletop use, affix one of the supplied self-adhesive rubber feet to each corner of the bottom of the switcher.

Rack mounting the switcher

All of the MVX Series VGA switcher models are housed in rack-mountable, 1U high, full rack wide metal enclosures. The appropriate rack mounting kit is included with each switcher. Rack mount the switcher as follows:

1.	If feet were previously installed on the bottom of the switcher, remove them.
2.	Attach the rack mount brackets to the switcher with the eight #8 machine
	screws provided (figure 2-1).

Mounting Screws (2 Plcs)

Each Side

Rack-mount

Bracket (Included)

Drill pilot holes 3/32” (2 mm) dia., 1/4” (6 mm) deep.

or

1

2

#8 Screw (4 Plcs)	Table/
	Wall-mount
Each Side
	Bracket (Optional)

Figure 2-1 — Mounting the switcher

O	UTPUTS
	3

1	4
2

7

	8
	5
INPUTS	6
3

4

A

				VGA
				88
			MVX		R
				L	7
					R
			R	L	8
		L	5
			R
	R	L	6
L	3
	R

7	1	R	L	4
	L	R		UTS
	2
	L			OUTP

5	8
6

RS-232

3.	Insert the switcher into the rack, aligning the holes in the mounting bracket
	with those of the rack.
4.	Secure the switcher to the rack using the supplied machine screws.

Furniture mounting the switcher

The MVX Series switchers can be mounted under a table or other horizontal surface with an optional Extron under-desk mounting kit (part #70-222-01).

1.	Secure the two table/wall mounting brackets to the switcher with the eight
	machine screws provided in the kit (figure 2-1).
2.	Hold the switcher with attached brackets against the underside of the desk or
	other furniture. Mark the location of holes for screws on the underside of the
	desk.

2-2 MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Installation