Philips 26PF5321D/37 user manual Perform installation, Multimedia browser

Perform installation

(Please skip this section if you have no cable connected to the Antenna input of the TV.)

&When the TV is powered-on for the first time you will be prompted to auto install the TV in order to receive the channels to receive the channels that are broadcasted locally.

Note - The TV will take approximately 10-15 seconds to start up.

éSelect the desired Language and press the green button "Next".

“Select Cable or Antenna in the Installation mode and press the green button "Next".

‘Auto Installation may take 20 to 40 minutes depending on the number of channels that are transmitted by the cable provider or broadcaster.

( When the TV is not receiving any signal from the antenna/cable, the message CHANNEL NOT AVAILABLE will appear on the TV screen. When no transmission is received from the broadcaster, a BLANK SCREEN will appear on the TV screen.

Note - The TV will go on to standby after 10 minutes. Press the POWER button on the remote control to on the TV.

§You will not be able to receive pay channels when using direct antenna/cable connection to the television.

èWhen the Set-top box is connected to the television using coaxial cable, it is necessary to auto-program the television for the single channel (3 or 4) that the Set-top box outputs and change the channels at the Set-top Box (using the set-top remote control) to view the program. Refer to the manual for more details.

Note - The newly installed channels maybe sorted in a deifferent sequence on this TV. Please key using the CH +/- buttons to get to know the new channel. Also you can use the OK key to see the list of channels.

!When the Set-top box is connected to the television using one of the AV connections (AV1/ AV2/ AV3/ HDMI), select that input source (using the AV+ button) to view the programs and change the channels at the Set-top Box (using the set-top box remote control) to view the program.

Française English

Multimedia browser

Multimedia browser lets you display pictures or play audio files stored on a USB device.

The Multimedia browser application is invoked from the My Content menu

(press the button) by selecting the USB device and pressing the cursor right.

Notes:

-Following file formats can be reproduced:

•For pictures: JPEG

•For audio: MP3, MP3 Pro

-Only FAT/DOS-formatted memory devices are supported.

-If your digital camera is not supported, make sure your camera is switched on and verify if its configuration settings are correct (see the manual of your camera).

-Philips cannot be responsible if your USB device is not supported.

Español

23