Extron electronic MVX 48, MVX 88 Operations, Powering up the switcher, Creating a set of ties

Operation, cont’d

Operations

The following paragraphs detail the power-up process and then provide sample procedures for creating ties, sets of ties, and configurations; changing a configuration; viewing ties, sets of ties, and configurations; saving a preset; recalling a preset; viewing and adjusting the audio level; and selecting the front panel security lockout.

Powering up the switcher

1. Plug in the switcher. On all switcher models, power is automatically applied

when the power cord is connected to an AC source. When AC power is applied, the switcher performs a self-test and initialization that sequences the front panel LEDs on and off from left to right. A successful power up self-test and initialization leaves the power LED on, the Video and Audio LEDs on, and all other LEDs off.

The current configuration, all presets, and all input audio levels are saved in non-volatile memory within 5 seconds of a change or exiting Audio Setup mode. When power is applied, the most recent configuration is retrieved. The previous presets remain intact.

Wait at least 5 seconds after changing any configuration, saving a preset, or exiting Audio Setup mode. Before 5 seconds have elapsed, changes that you have made may not have been saved.

	If an error occurs during the self-test, the switcher locks up and does not
	operate. If your switcher locks up on power-up, call the Extron S3 Sales &
	Technical Support Hotline.
2.	Plug in all system components and turn on the input devices (such as
	computers or HDTV set-top boxes) and the output devices.
3.	Set the input devices to output video using each device’s own operating
	instructions.
4.	Create a tie (see below). The selected input image should appear at the
	selected output. If no image appears, see Troubleshooting on page 3-26.

Creating a set of ties

You can create a set of ties, changing the current configuration, by using the front panel buttons. Change the current configuration as follows:

1.	Select to configure video, audio, or both by pressing the I/O button as
	necessary.
2.	Select the desired input and output(s) by pressing the input and output
	buttons.
3.	Press and release the Enter button.
4.	Repeat steps 1 through 3 to create additional ties until the desired

configuration is complete.

• Only one video input and one audio input can be tied to an output.

• If a tie is made between an input and an output, and the selected output was previously tied to another input, the older tie is broken in favor of the newer tie.

• Output LEDs light when an input is selected to indicate current ties. Press and release the associated output buttons to clear unwanted outputs.

3-6 MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation