Extron electronic MVX 44, MVX 88, 48 Example 2 Add a video tie to a set of video and audio ties

Example 2: Add a video tie to a set of video and audio ties

In the following example, a new video tie is added to the current configuration. The example shows the front panel indications that result from your actions.

NOTE: This example assumes that you have performed example 1.

1.Select video only for the tie: If necessary, press and release the I/O button to cycle through the selections until the only the Video LED lights.

Press the button.

I/O

The video LED lights when video is selected. VID

The audio LED is off when audio is deselected. AUD

2.Select an input: Press and release the input 5 button.

Press and release the Input 5 button.

4	INPUTS			2		4	OUTPUTS
	5	6	1		3		5	6	7	8

The Input 5 LED lights to indicate that input 5 is selected.

The Output 3, Output 4, and Output 8 LEDs light to indicate the ties created in example 1.

3.Select the output: Press and release the output 1 button.

Press and release the Output 1 button.

OUTPUTS

1 2 3 4 5 6 7 8

The Output 1 LED blinks to indicate that the selected input will be tied to this output.

= Blinking LED

4.Confirm the change: Press and release the Enter button.

Press the Enter button to confirm the configuration change.

ENTER

The LEDs for the selected input, the selected outputs, and the tied outputs light steadily for approximately 1 second to indicate the tie and then go out.

INPUTS			OUTPUTS
5	1	3	4	8

1 second

The current configuration is now input 5 video tied to output 1, output 3, output 4, and output 8 (see figure 9).

Input 5 video tied

to outputs 1, 3, 4, and 8. Input 5 audio tied

to outputs 3, 4, and 8.

Input

5

1

3

4 Output

8

Video Audio

Figure 9. Example 2 Configuration

MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation 15