Front Panel Cover
The front panel has a lockable cover to prevent unauthorized access to the removable drives. The cover has five light tubes that allow the signals from the front panel LEDs to be seen when the cover is in place.
VNR 100
Recorder
Light Tubes
Projections
(2 on each end)
Release Catch
Lock
Figure 6. VNR 100 Front Panel Cover
To install the front cover:
1.Ensure the Lock is in the open position ( 
). If necessary, use the provided key to undo the lock.
2.Holding the cover at a slight angle, slide the two projections on the left side of the cover into the holes on the inside surface of the handle (A in the figure below).
3.Press the release catch inwards to retract the two projections on the right side of the cover and slide the cover into place.
4.Release the catch to allow the two projections to fit into the holes on the surface of the handle.
5.If required, use the key to lock the cover in place.
Handle
VNR 100
Recorder
Figure 7. VNR 100 Front Panel Cover, installed
Remove the cover by reversing these steps.
Front Panel Features
a | b | c c d | e fg a | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
h | i | j | j |
Figure 8. VNR 100 Front Panel
The front panel has a removable bezel, which can be locked in place to secure the media drives. When the bezel is locked in place the DVD player, USB ports, and serial ports are not available for use.
NOTE: It is not necessary to access the front panel during normal operation of the
VNR 100.
AHandles (2) — the VNR 100 is mounted on sliding rails in a standard rack. The handles allow the unit to be pulled in and out of the rack on the rails. They are also used to secure the front panel bezel.
BCD and DVD drive — used for system updates or software installation.
VNR 100 • Panels and Cabling | 9 |
