Extron electronic VNR 100 manual Getting Started with the Enterprise Controller

Getting Started with the Enterprise Controller

The VNR 100 Single channel recorder is controlled by the VNM Enterprise Controller, which is used to configure and manage all Matrix devices in the system.

VNR 100 devices are used with VN-Matrix encoders and decoders to record and play back PURE3 streams. VNR 100 devices may be controlled singly or in groups to enable recording and playback of more than one stream.

System settings are configured as presets that may then be recalled from either the VNM Enterprise Controller WEB UI or from an external control system connected to the VNM Enterprise Controller using the HLI command protocol.

1.Use a PC on the same network as the VNM Enterprise Controller to access the website for the controller. Enter the IP address for the controller in the address bar. The controller Login screen opens:

Figure 11. Enterprise Controller Login Screen

2.Enter the Username and Password.

3.Click Login. The Enterprise Controller Device List opens:

Figure 12. Enterprise Controller Device List

4.Check the box next to the VNR 100 recorder. A series of action buttons appear at the bottom of the screen:

Figure 13. Enterprise Controller Device List Action Buttons

Use the Enterprise Controller User Guide (at www.extron.com) for complete information about configuring and using the VNR 100 recorder.

VNR 100 • Configuration and Hardware Setup 14