Extron electronic manual VNR 100 Power Up Procedure, VNR 100 Power Down Procedure

VNR 100 Power Up Procedure

NOTE: Before turning on the VNR 100, ensure all necessary devices are connected correctly and powered up.

Power up the VNR 100 by pressing the Power button (G in figure 8). The VNR 100 boots up.

VNR 100 Power Down Procedure

Power off the VNR 100 by pressing and releasing the front panel power button. The recorder takes approximately 20 to 30 seconds to power-down.

Initial Configuration of the VNR 100

The initial configuration of the VNR 100 allows it to connect to the Enterprise Controller. Once it is integrated into the Enterprise Controller network, the VNR 100 will be completely controlled by the Enterprise Controller.

By default, the VNR 100 is pre-configured with the following network settings:

•	IP Address:	192.168.254.254
•	Subnet Mask:	255.255.225.0
•	Port Number:	8080

You will need to contact your network administrator to find out the IP address for the

Enterprise Controller.

To perform the initial configuration, follow these instructions:

1.Initial configuration is through the browser of a computer connected to the same network as the VNR 100. In the browser address bar, enter the IP address of the recorder followed by a colon and the port number (for example: 192.168.254.254:8080).

The login page opens:

Figure 9. VNR 100 Login to Web Page

2.Enter the Username and Password.

NOTE: By default, the Username and the Password are both config.

VNR 100 • Configuration and Hardware Setup 12