3.Click Login. The VNR 100 Recorder Settings page opens:
|
|
| Logout |
|
| VNMatrix recorder settings |
|
|
| Network settings [eth0] |
|
IP Address |
| 192.168.254.254 |
|
Subnet Mask | 255.255.255.0 |
| |
Gateway |
| 192.168.254.253 |
|
|
| Recorder settings |
|
Serial |
| 1111999 |
|
Controller IP |
| 192.168.254.254 |
|
Controller port | 5432 |
| |
MTU |
| 1500 |
|
|
| User settings |
|
New password |
|
| |
Confirm New password |
|
| |
|
| Data disk |
|
Umount | status: | mounted to /home/matrix_rec/Recording_Files | |
Disk free space: |
| ||
Format |
| formated to ext3 |
|
|
| Apply Changes | Cancel Changes |
Figure 10. VNR 100 Web Page
4.Enter the IP Address, Subnet Mask, and Gateway address of the recorder.
5.Enter the Controller IP address, Controller port number and maximum transmission unit (MTU) setting of the controller.
6.Enter a New password and Confirm New password.
7.Click Apply Changes to save the settings (or click Cancel Changes to exit without saving the information).
ATTENTION: There is no indication whether you have been successful or unsuccessful in connecting to the Enterprise Controller. To verify that the recorder has linked to the controller, you must log on to the controller and ensure that the recorder is in the device list.
IP Address and Subnet mask — are assigned to the ETH0 NIC on the VNR100.
Gateway — is the IP address of the gateway that is assigned to the ETH0 NIC on the VNR100. If no gateway exists, the IP address should be the same as the system contoller.
Controller IP Address — is the IP address of the Enterprise Controller used to control the VNR100.
Controller Port — is the port number is used by all VN_Matrix devices to communicate with the Enterprise Controller. The value should only be changed if the Enterprise Controller has been configured to accept communications on a different port number. Under normal circumstances the setting should remain at the default setting (5432).
Maximum Transmission Unit (MTU) — is used to set the packet size, in bytes, that is used to transmit data over the network. The default is 1500 bytes. This setting is for advanced use only. Under normal circumstance do not change this value from the default value. If the MTU value is incorrectly set, the MATRIX system may malfunction.
New password — Change the default password for the config account if required. The User account name cannot be changed.
Data (media) disk
VNR 100 • Configuration and Hardware Setup 13