3 41 01 091 21 0.book Seite 14 Dienstag, 24. Juli 2007 3:32 15
ENMULTIMASTER FMM 250 / MULTIMASTER FMM 250 Q
Working instructions.
WARNING Before mounting or replacing application tools or accessories, pull the power plug. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respec- tive application.
Connecting the dust extraction (Figure 2, ➐).
| Whenworkingmaterialsthat |
CAUTION | |
| produce dust, the power tool |
is to be connected to an external dust extrac- tion via the extraction adapter.
The vacuum cleaner must be suitable for the material being worked.
When vacuuming dry dusts that are partic- ularly hazardous to one’s health or carcino- genic, a specialty vacuum cleaner is to be used.
Decreasing the oscillating frequency:
➤Turn dial control in clockwise direc- tion.
The oscillating frequency depends on the application and the application tool. Exam- ple:
–High oscillating frequency:
Sanding, sawing, using as a rasp, polishing stone and metal.
–Low oscillating frequency:
Polishing of varnish and veneers, removal of grout, teak decks from boats.
Switching ON and OFF (Figure 1).
|
| First check that the power | |
| WARNING | ||
| cable and power plug are | ||
not damaged. | |||
| |||
|
| Always hold the power tool | |
| CAUTION | ||
|
| firmly. Otherwise, you | |
could lose control over the power tool.
Switching ON:
➤Push the switch towards the front (I).
Switching OFF:
➤Push the switch towards the back (0).
Setting the oscillating frequency (Figure 1).
The oscillating frequency can be set infi- nitely variable with the dial control.
Increasing the oscillating frequency:
➤Turn dial control in counterclock- wise direction.
Securing the work piece.
| Secure the workpiece firmly. |
CAUTION | |
| A work piece that is gripped |
tightly in a clamping device or vice, is more secure than if held by hand.
Sanding
Typical application: Dry sanding of wood and metal, especially of smaller surfaces, corners and edges, as well as hard to reach locations.
Work with the complete surface of the sanding plate, not only with the tip. Select a high oscillating frequency. Sand with con- tinuous motion and light pressure. Applying excessive pressure does not increase mate- rial removal; only the sanding sheet wears more quickly.
Sawing
Typical application: Sawing of thin steel sheet, wood and plastic components.
Select a high oscillating frequency.
14
