FieldServer FS-8700-17 instruction manual Only one module position may be

	FS-8700-17 Optomux				Driver Manual
Read/		COMMAND NAME	OPTO22_FORMAT	MASTER LENGTH	NOTES
Write/			OPTION	CONSIDERED (See
Both				Notes)
r		READ AND AVERAGE INPUT		4	Only one module position may be
					specified. This position is averaged
					and the result is put in the first
					element of the data array The number
					of samples is specified in modifier1 in
					the csv file.
w		START INPUT AVERAGING		3	Only specified module positions get
					affected by command. First element
					in data array is sent as the number of
					sample to average over.
r		READ AVERAGE COMPLETE BITS	1	2	If format=Bit then length is considered
					during storage as bits are unpacked
					into data array. If format is non equal
					to bit then result is written as a single
					value into one array element.
					Retrieved data is stored in standard
					data array.
r		READ INPUT AVERAGE DATA		3	Only specified module positions get
					read. Data read gets put in
					corresponding positions of data array.
r		READ TEMPERATURE INPUTS		3	Only specified module positions get
					read. Data read gets put in
					corresponding positions of data array.
r		READ AVERAGE TEMPERATURE INPUTS		3	Only specified module positions get
					read. Data read gets put in
					corresponding positions of data array.
w		SET INPUT RANGE		3	Only specified module positions have
					their range set to the 2 values found
					in the data array. 1st is high limit,
					second is lo limit.
r		READ OUT-OF-RANGE LATCHES		4	High limit latches are placed in first
					element of data array. Low limit
					latches are placed in 2nd element of
					data array.
b		READ AND CLEAR RANGE LATCHES		3	Only specified module positions get
					read and cleared. Data read gets put
					in corresponding positions of data
w		CLEAR OUT-OF-RANGE LATCHES		4	array.
r		READ LOWEST VALUES		3	Only specified module positions get
					read. Data read gets put in
					corresponding positions of data array.
w		CLEAR LOWEST VALUES		3	Only module positions specified get
					affected by command.
b		READ AND CLEAR LOWEST VALUES		3	Only specified module positions get
					read and cleared. Data read gets put
					in corresponding positions of data
					array.
r		READ PEAK VALUES		3	Only specified module positions get
					read. Data read gets put in
					corresponding positions of data array.
w		CLEAR PEAK VALUES		3	Only module positions specified get

FieldServer Technologies 1991 Tarob Court, Milpitas, California 95035 (408) 262-2299 fax: (408) 262-9042

Visit our website: www.fieldserver.com E-mail: support@fieldserver.com

Page 23