US | 14 Installation instructions |
CA |
|
| Fastening the cooktop to the counter |
|
1Turn the cooktop upside down and place it on a soft surface.
2Spread the seal around the edges of the cooktop with the adhesive side facing down, as shown in Figs. 6 and 7. Make sure that the whole perimeter is sealed. Cut off any excess material.
3Mount the supplied clamps (A) and screws (B) onto the cooktop, as shown (without tightening the screws).
4Place the cooktop into the cutout, then tighten the screws to clamp the cooktop securely to the counter.
5Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop. Take care not to damage the countertop.
Note: if the countertop is thicker than 1 9⁄16” (40 mm), recess the underside to between 1 3⁄16” (30 mm) and 1 9⁄16” (40 mm).
Fitting the clamps
1 2
Seal
Adhesive side | Clamp position |
|
Seal
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| " (30 mm) min. |
| " (40 mm) max. |
|
|
|
|
|
|
|
| ||
|
|
|
|
| 16 |
| 16 |
|
|
|
|
|
| / |
| / |
|
Clamp | Screw | 3 |
| 9 |
| |||
1 |
| 1 |
| |||||
|
|
Fig. 6 Preparing the cooktop before installation
Seal
Fig. 7 Fastening the cooktop to the counter