US CA 16 Installation instructions
Installing the gas pressure regulator
1Prepare the elbow connection:
First use a wrench to loosen the manifold female pipe fitting and then turn the elbow connection in the required direction.
Once you have the spatial arrangement required, use a wrench to
Note: when tightening the connection, make sure you hold it firmly in position (eg by
using adjustable pliers or an adjustable wrench) and take care not to damage the thread.
2Connect the extension pipe to the elbow:
Mount the extension pipe to the elbow connection, making sure you place the supplied
washer between them.
Note: when tightening the connection, make sure you hold it firmly in position (eg by
using adjustable pliers or an adjustable wrench) and take care not to damage the thread.
3Prepare the gas pressure regulator:
Mount the 3/8” NPT (conical) male connector to the gas pressure regulator and tighten by
using a wrench.
Note: take care not to overtighten the connector, as doing so may crack the gas pressure
regulator.
4Connect the gas pressure regulator assembly to the extension pipe:
Mount the gas pressure regulator assembly to the extension pipe, making sure you place the supplied washer between them (see Fig. 11).
Important!
Use two wrenches to tighten the connection.
UNLOCK
To cooktop
LOCK
Fig. 8 Preparing the elbow connection
To cooktop
LOCK
Fig. 9 Connecting the extension pipe to the elbow
LOCK
Arrow
Fig. 10 Preparing the gas pressure regulator
Fig. 11 Connecting the gas pressure regulator assembly to the extension pipe