PANEL PREPARATION INSTRUCTIONS
STEP 7: FITTING THE PANELS TO THE PRODUCT
Fit the assembled Panel by sliding in an inwards and upwards motion. The rubber seal between the Drawer and Panel must be kept in place.
Secure the Panel by inserting the pins on either side of the Drawer. Be sure that the rib on the pin is vertical.
Important!
The airflow gap between the bottom of the door panel and adjacent cabinetry must be 3/8” (9mm) or drying problems and moisture damage may occur.
INTEGRATED PANEL PREPARATION IS COMPLETE.
The Product is now ready to install. Refer to Product Installation
Instruction Sheet P/N 526607.
CUSTOMER CARE
If you have any questions concerning the installation ofthis , please contact your Fisher & Paykel Authorized Service Agent.USA
Fisher & Paykel Appliances
27Hubble Irvine CA 92618
Toll Free 1 888 9 FNP USA1 888 9 367 872
www.usa.fisherpaykel.com
6