Fisher & Paykel DD603I Low Installations, Integrated Panel Thickness, Integrated Panel Material

BEFORE YOU START

LOW INSTALLATIONS

Use this diagram if installing the near floor level.

IMPORTANT

INTEGRATED PANEL THICKNESS

Panel minimum thickness is 16mm. Panel thicknesses above 18mm can be accommodated but product depth will increase accordingly.

INTEGRATED PANEL MATERIAL

Drawer Front material must be suitable for damp conditions

(122oF/50oC @ 80% RH) or adequately sealed to withstand moisture. Additional protection can be provided by using a “Moisture Resistant Board”. Taping edges alone may not provide adequate sealing. For painted panels, radius all rear edges to improve sealing.

WARNING!

ENSURE THE PRODUCT IS NOT PLUGGED IN.

Important!

The installation of the Panel requires an electrical connection and must be performed by a suitably qualified person.

PARTS SUPPLIED

INTEGRATED PARTS KIT part no. 526675

Integrated Rectangular Badge (1) (Satin Chrome supplied)

p.n 526975

Other Colours Available Rectangular:

Bright Chrome Kit p.n 527276 Brass Kit p.n 527277 Eliptical:

Black Kit p.n 526683

Satin Chrome Kit p.n 526684 Bright Chrome Kit p.n 527156 Brass Kit p.n 526685

Mounting Bracket (1) p.n 526440

Door Front Seal (1) p.n 526466

Panel	Panel
Preparation	Mounting
Booklet (1)	Screws (6)

TOOLS NEEDED

Safety Glasses, Tape Measure, Pencil, Needle-Nose Pliers, Drill & Phillips Bit or Phillips Screwdriver, ø 1” (25.4mm) Boring Bit or ø 1” (25.4mm) Hole Saw, Small Hand or Jig Saw.

2