Fisher & Paykel DD603I Customer Care, Fitting The Panels To The Product, Instruction Sheet P/N

R

PANEL PREPARATION INSTRUCTIONS

STEP 7: FITTING THE PANELS TO THE PRODUCT

Fit the assembled Panels by sliding in an inwards and upwards motion.The rubber seal between the Drawer and Panels must be kept in place.

Secure the Panels by inserting the pins on either side of the Drawer. Be sure that the rib on the pin is vertical.

NOTE: Do not fit the Toe Kick Panel (or supplied Black

Prefinished Toe Kick) to the R until the Product is in the cavity.

Important!

The gap between doors must be 5/16” (8mm) or drying problems and moisture damage may occur.

INTEGRATED PANEL PREPARATION IS COMPLETE.

The Product is now ready to install. Refer to Product InstallationInstruction Sheet P/N 526607.

CUSTOMER CARE

If you have any questions concerning the installation of

this R , please contact your Fisher & Paykel Authorized Service Agent.

USA

Fisher & Paykel Appliances27Hubble Irvine CA 92618

Toll Free 1 888 9 FNP USA

1 888 9 367 872

www.usa.fisherpaykel.com

6