US
part number 526608 J 06/2004 (page 1 of 6)
S I N G L E
I N T E G R A T E D P A N E L P R E P A R A T I O N
FOR INTEGRATED SINGLE MODELS DS603I(NOTE: FOR DOUBLE
MODELS, REFER TO BACK OF THIS BOOK)PLEASE NOTE: Your model of 
may differ from the model shown in the diagrams. Diagrams have been simplified to enable clearer instruction.
FOLLOW THESE INSTRUCTIONS BEFORE REFERRING TO PRODUCT INSTALLATION INSTRUCTION SHEET P/N 526607.
BEFORE YOU START
openBe sure the Product is not plugged in.
The Door of the 
can be made to match your kitchen cabinetry. This diagram, with the addition of your own measurements will help you calculate the required panel sizes.
WIDTH OF THE PANEL
Measure 
the width between adjacent door/drawer fronts and write it
in the first box below, then complete the equation. |
|
|
| ||||||
|
|
|
| 2 x |
|
|
|
|
|
For example: | 241/4” (616mm) |
|
| 3/32” (2.5mm) |
|
|
| 241/16” (611mm) | |
|
| ||||||||
|
| ||||||||
|
|
|
|
| door clearance |
|
| panel width | |
2x
door clearance | panel width |
(3/32” (2.5mm) MIN) | (23 7/16” (595mm) MIN) |
HEIGHT OF THE PANEL
Measure 
door/drawer height (or equivalent) and write it in the first box below, then complete the equation.
For example: | 16” (407mm) |
|
| 3/8” (9mm) |
|
| 155/8” (398mm) |
|
|
| |||||
|
|
|
| ||||
|
|
|
| air gap | panel height | ||
gap between | panel height |
panels | (155/8” (398mm) MIN) |
Note: When the top of the 
has to be lower than the adjacent cabinetry, the Panel can be increased in height.
WARNING!
The air vent between the Panel and the adjacent cabinetry must not be covered. An air gap of 3/8” (9mm) MUST be provided.
