R
PANEL PREPARATION INSTRUCTIONS
READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY.
STEP 1: BADGE AND HANDLE POSITION
BADGE AND HANDLE POSITIONS
On both Panels, select the Badge position to suit the cabinetry design, within the available badge zones.
The Badge may be centered on the edge of the badge zone.
The handle position will also need to be taken into account.
STEP 2: BADGE CUT-OUT & BRACKET REMOVAL
(Not shown to scale)
BADGE CUT-OUT
Cut the badge slot in each Panel by drilling two 1” (25.4mm) diameter holes and cutting out the remaining material between the holes. A hole center to hole center template is provided on the Mounting Backet.
WARNING!
Be sure the Product is not plugged in.
Important!
Accuracy is essential when cutting the Badge slot to be sure of a neat fit to hold the Badge.
REMOVING THE BRACKET
1)To remove the Mounting Brackets withdraw the pins from the Drawer sides, using a pair of
2)Gently slide the Mounting Bracket off in a downwards and outwards motion. Disconnect the Mounting Bracket and Badge grounding wires, also unplug the Badge harness from the Badge Isolator box. Remove the Badge from the Mounting Bracket.
NOTE: The four 1/8” (3.3mm) holes on the perimeter of the rectangular recess in the Mounting Bracket can also be used to define the badge zone.
3
