12a PULL THROUGH HOSES & MOVE INTO THE CAVITY
13a SECURE THE DRAWER | 15 |
|
Vent Hose (Integrated models with remote (NZAU) only)
Open the drawer halfway.
Using a
of the trim moulding.
2
Using a small Philips screwdriver, screw through the trim
1
Replace the grey rubber plug back into the trim moulding and ensure the trim seal is facing forward.
3
vent either through same cabinet or adjacent cabinet as per step 7b or 7c
As you push product in, pull through hoses and cord, ensuring they don’t get kinked or twisted.
moulding, securing the side mounting bracket to the cabinetry.
Do not damage the rubber trimseal.
Repeat for all
Important!
If product cannot be pushed in far enough, pull out again and rearrange hoses and cord. Do not use excessive force, as doing so may squash the hoses and lead to incorrect operation.
four brackets.
14a 
INTEGRATED MODELS WITH REMOTE (NZ AU) ONLY - SECURE THE EXTERNAL VENT
1 | 2 |
|
After routing the vent hose through and out the hole cutout, attach and secure the vent by tightening the four screws provided.
