Manuals / Fisher & Paykel / Kitchen Appliance / Dishwasher

Fisher & Paykel DD60S 7, DD60ST 7 External Venting kit, Panel bracket, Panel mounting, screws

Models: DD60S 7 DD60ST 7

1 23

Page 5

3b ADDITIONAL PARTS SUPPLIED WITH INTEGRATED MODELS	5

External Venting kit (1)

supplied with Integrated models with remote (NZ AU) only

Panel bracket (1)	Panel mounting	Integrated rectangular badge (1)
(attached to	screws (6)	(Satin chrome supplied)
product)
		supplied with Integrated models
		with badge (GB IE) only
		with badge (GB IE) only

Page 5

Image 5

Fisher & Paykel DD60S 7, DD60ST 7 External Venting kit, Panel bracket, Panel mounting, screws, with badge GB IE only

Contents

DishDrawerTM dishwasher INSTALLATION INSTRUCTIONSNZ AU GB IE DD60S 7 & DD60ST 7 modelsSTANDARD HEIGHT SINGLE MODELS IMPORTANT SAFETY INSTRUCTIONS 2a SAFETY AND WARNINGS - ALL MODELSIMPORTANT SAFETY INSTRUCTIONS Electrical shock hazardOPTIONAL 3a PARTS SUPPLIED - ALL MODELSPanel bracket External Venting kitPanel mounting screwsProduct dimensions mm 4 PRODUCT DIMENSIONSPlan 5CABINETRY DIMENSIONSCabinetry dimensions mm WIDTH OF THE PANEL FRONT PANEL SPECIFICATIONSHEIGHT OF THE PANEL min. 2 mmWIDTH OF THE PANEL FRONT PANEL SPECIFICATIONSHEIGHT OF THE PANEL min. 2 mm10 Water Connection 7a CAVITY PREPARATIONWater Pressure Water softener modelsShelf cutouts Shelf cutoutsPower cord excl. plug - 1650 mm Power cord excl. plug - 1650 mmLeft hand side Right hand sidethe prongs engage with the top tabs and it clicks into placeFirmly push the bracket so that ATTACH VENTING HOSE 10a ATTACH SIDE MOUNTING BRACKETS11a INTEGRATED MODELS WITH REMOTE NZ AU ONLY NOW CHOOSE WHICH INSTALLATION METHOD a or b13a SECURE THE DRAWER 12a PULL THROUGH HOSES & MOVE INTO THE CAVITYRepeat for all four brackets11b PULL THROUGH HOSES & MOVE INTO THE CAVITY 10b INTEGRATED MODELS WITH REMOTE NZ AU ONLYATTACH VENTING HOSE ALTERNATIVE METHOD b - SECURE BY DRAWER REMOVAL13b SECURE THE DRAWER TO THE CABINETRY 12b REMOVE THE DRAWER14b REFIT THE DRAWER ONTO THE RUNNERS 15b INTEGRATED MODELS WITH REMOTE NZ AU ONLY17a ATTACH PANEL TO PANEL BRACKET 16a REMOVE BRACKET FROM PRODUCT18a EARTH THE PANEL 19a ATTACH PANEL TO PRODUCT+ or - 2 mm 16b DETERMINE BADGE CUTOUT LOCATION 18b ROUTE BADGE WIRING THROUGH PANEL17b REMOVE BRACKET & DISCONNECT BADGE 19b ATTACH PANEL TO PANEL BRACKET21b ATTACH PANEL TO PRODUCT 20b REATTACH BADGE & EARTH THE PANELPush the panel in then up to locate25PLUG PRODUCT IN 24CONNECT INLET HOSE TO COLD WATERDishwasher using sink trap with drain hose joiner Dishwasher and Standpipe Ø 38 mm27 TROUBLESHOOTING 26FINAL CHECKLISTSAVE THESE INSTRUCTIONS The dishwasher is beeping continuously

External Venting kit (1)

Panel bracket (1)

Panel mounting

supplied with Integrated models

with badge (GB IE) only