|
| INTEGRATED MODELS WITH BADGE (GB IE) ONLY - INSTALLING THE FRONT PANEL & BADGE CONTROLS | 21 | |
|
| |||
|
| |||
20b REATTACH BADGE & EARTH THE PANEL | 21b ATTACH PANEL TO PRODUCT |
| ||
2
1
WARNING!
Electrical Shock Hazard
Connect the integrated badge earth wire to one of the two tabs provided on the panel bracket.
To earth the panel bracket, connect the earth wire from the product to the other tab.
Any custom metal component (e.g. handle) that extends past the rubber seal must be earthed too.
Failure to follow these warnings may result in electrical shock, injury or fire.
| Important! |
| Ensure the rubber seal |
| between the drawer |
| and panels is kept in |
2 | place. |
1
Push the panel in | 2 |
then up to locate. |
|
When refitting the door pins, ensure they are orientated as shown.
22b ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS
With the front panel fitted, insert an appropriately sized Philips screwdriver into the hole above the door pin and rotate the panel up or down to align the gaps in your cabinetry.
| Repeat on the other side if necessary. |
+ or - 2 mm | The panel has a maximum travel of 2 mm up or |
| down. |
Important!
Ensure that you maintain a minimum of 8 mm ventilation gap below the panel.
