SU4/UF2
INITIAL SETUP
When you are setting up the VCR for the first time, or after the power has failed for more than 5 seconds, follow the steps below. This AUTO SETUP operation automatically enters all available channels in your area into the VCR tuner memory and sets its internal clock.
Many TV stations transmit a signal called Extended Data Services (XDS). This VCR uses the XDS signal to automatically set the clock. If no XDS signal is available in your area, the VCR prompts you to set the clock manually.
AUTO SETUP
Before starting
œBe sure the antenna or cable connections are correct. (See pages 11 and 12.)
1Turn on the power (TV and VCR).
2Set the TV to channel 3 or 4.
3Press the VCR button on the remote control to select the VCR operation mode.
4If the VCR indicator is off, press the TV/VCR button on the remote control.
The VCR indicator lights.
The “Auto Setup” message appears.
@@@@@@@Auto@Setup
5Press the SET button.
The Language select menu appears.
@@@@Language@select
@@@@@@@@English
@@@@@@@@Español
@@@@@@@@Français
6Press the CH/TRACK l (or j) button to move down or up the list and highlight the language of your choice. Press the SET button.
The menu language is selected.
“Auto tuning memory” appears on screen. The VCR scans all 125 channels and memorizes each active channel in your area in succession. It takes about
7When Auto Tuning is completed, the VCR will select the channel that carries the XDS signal and proceed to Auto Clock setting.
@@@@@@@Clock@set
The Auto Clock setting normally takes about
3 minutes. During this time, the VCR's front panel shows the channel number that is sending the XDS signal for Auto Clock setting. Make a note of this number, which you may need to refer to for readjusting the clock later (see page 20).
If the Auto Clock setting entered the incorrect date and/or time, correct it by following the steps under Automatic Clock Adjustment on page 20.
If no XDS signal is available in your area:
“Clock set” will not appear on the screen when the Auto Tuning operation is completed. Instead, the TV program on the lowest channel that the VCR memorized will appear on screen. In this case, you must set the clock manually. Follow the steps under Manual Clock Setting on page 21.
NOTES:
œDuring AUTO SETUP, do not press any buttons other than the ones indicated here.
œThe VCR will search for and memorize channels in the CATV (cable TV) mode and TV mode. If you are not using a cable converter/decoder, follow steps 1 – 4 under “PROGRAMMING CHANNELS” on page 22.
œIf the AC power to the VCR is interrupted for more than 5 seconds, the memorized channels may be erased.
BASIC OPERATION
15
