Contents | Fortinet 224B specs

Contents

Contents
Contents	3
Introduction	7
Register your FortiGate unit	7
About the FortiGate-224B	8
About this document	8
Document conventions	8
Typographic conventions	9
Further Reading	9
Fortinet Knowledge Center	10
Comments on Fortinet technical documentation	10
Customer service and technical support	10
Installing	11
Environmental specifications	11
Cautions and warnings	12
Grounding	12
Rack mount instructions	12
Mounting	12
Plugging in the FortiGate	14
Connecting to the network	14
Turning off the FortiGate unit	14
Configuring	15
NAT vs. Transparent mode	15
NAT mode	15
Transparent mode	16
Connecting to the FortiGate unit	16
Connecting to the web-based manager	16
Connecting to the CLI	17
Configuring NAT mode	18
Using the web-based manager	18
Configure the interfaces	18
Configure a DNS server	19
Adding a default route and gateway	19
Adding firewall policies	20
Using the CLI	21
Configure the interfaces	21

FortiGate-224B FortiOS 3.0 MR6 Install Guide
01-30006-0451-20080815	3

Image 3

Fortinet 224B manual Contents

Contents

Install G U I D E Regulatory compliance Trademarks Contents FortiGate Firmware Advanced configuration Installing firmware from a system reboot using the CLI Testing new firmware before installingIndex Page Register your FortiGate unit Introduction About the FortiGate-224B About this documentDocument conventions Typographic conventions Further Reading Customer service and technical support Fortinet Knowledge CenterComments on Fortinet technical documentation Environmental specifications Installing Grounding Rack mount instructionsMounting Installed mounting brackets To install the FortiGate unit into a rack Plugging in the FortiGate Connecting to the networkTo power on the FortiGate unit To power off the FortiGate unit NAT mode NAT vs. Transparent mode To connect to the web-based manager Connecting to the FortiGate unitTransparent mode Connecting to the web-based manager To connect to the CLI Connecting to the CLI To configure interfaces Go to System Network Interface Configuring NAT modeUsing the web-based manager Configure the interfaces Adding a default route and gateway Configure a DNS server Adding firewall policies To modify the default gateway Go to Router Static Using the CLI To set an interface to use a static addressTo set an interface to use Dhcp addressing To set an interface to use PPPoE addressing To configure DNS server settings To add an outgoing traffic firewall policy To modify the default gateway Configuring Transparent mode Switching to Transparent modeTo switch to Transparent mode Go to System Status Source Address All Destination Interface To switch to Transparent mode Backing up the configuration Verify the configuration Set the time and date Restoring a configurationAdditional configuration Set the Administrator password Updating antivirus and IPS signatures Configure FortiGuard Additional configuration Protection profiles Advanced configuration Firewall policies Firewall policies Antivirus options Configuring firewall policies AntiSpam options Web filtering Logging Downloading firmware FortiGate Firmware Using the web-based manager Upgrading the firmwareReverting to a previous version Backup and Restore from a USB key Using the USB Auto-InstallTo revert to a previous firmware version To upgrade the firmware using the CLI Using the CLI To revert to a previous firmware version using the CLI Execute restore image namestr tftpip4 Execute restore image namestr tftpipv4 Installing firmware from a system reboot using the CLI Press any key to display configuration menu To install firmware from a system reboot To backup configuration using the CLI Restoring the previous configuration Additional CLI Commands for a USB key To restore configuration using the CLITo configure the USB Auto-Install using the CLI To test the new firmware image Testing new firmware before installing Testing new firmware before installing Testing new firmware before installing Index Web filtering 35 web-based manager Page Page