Inserting a FortiGate-5001FA2 board into a chassis

Hardware installation

7Turn both handles to their fully-closed positions.

The handles should hook into the sides of the chassis slot. Closing the handles draws the FortiGate-5001FA2 board into place in the chassis slot and into contact with the chassis backplane. The FortiGate-5001FA2 front panel should be in contact with the chassis front panel. When the handles are fully-closed they lock into place.

Alignment Pin

Close

Alignment Pin

 

Handle

Fully Closed

 

 

and Locked

If the chassis is powered on, as the board slides into place the IPM LED starts flashing blue.

8Fully tighten the left and right retention screws to lock the FortiGate-5001FA2 board into position in the chassis slot.

.

Retention

Screw

Tighten

If the chassis is powered on the PWR LED turns green and the STA LED turns red. The ACC LED also starts flashing red. After a few minutes, if the board is operating correctly the front panel LEDs are lit as described in Table 4.

Table 4: FortiGate-5001FA2 normal operating LEDs

LED

State

PWR

Green

ACC

Off (Or flashing red when the system accesses the flash disk.)

STA

Green

IPM

Off

 

FortiGate-5001FA2 Security System Guide

16

01-30000-0379-20080606

Page 16
Image 16
Fortinet manual FortiGate-5001FA2 normal operating LEDs