Franke Consumer Products 4GAV-TC, PRI 5 Technical Data, Installation, Category II 2H3+ appliance

PREVIOUS DOCUMENT

Technical Data

Category II 2H3+ appliance

TYPE OF GAS

G20

natural gas (methane) 20 mbar

G30-G31

liquefied gas

30/37 mbar

BURNER

Small

Medium

Fast

Triple-ring

Small

Medium

Fast

Triple-ring

INJECTOR MARKING

72

97

115

140

50

65

85

91

RATED THERMAL	REDUCED THER-
CAPACITY	MAL CAPACITY
IN WATTS	IN WATTS
1000	400
1750	440
3000	800
3300	1600
1000	400
1750	440
3000	800
3300	1600

RATED

CONSUMPTION

95l/h

167l/h

286l/h

314l/h

73g/h

127 g/h

218 g/h

240 g/h

E N G L I S H

Overall thermal capacity: see the identification plate on the bottom of the cooktop.

Combustion supporting air: 2 m3/h per kW of installed power - see identification plate.

Supply voltage: 220/230 V 50 Hz

Installation

Installation and connection to the mains should be carried out in compliance with national laws in force.

The following paragraphs describe installation procedures both for the gas and for the electrical sections. These tasks must be performed according to current standards and by qualified personnel: performance by inexpert persons can create dangers. The manu- facturer declines all responsibility for harm to persons or property caused by failure to comply with these requirements.

Important

-The appliance must be installed by expert and qualified personnel according to current standards.

-Turn to a Franke Service Centre for all repairs and maintenance.

-Never use deformed or unstable pots and pans on the burners which could overflow or tip over.

-If the appliance has a cover make sure the burners are cool before closing the cover.

-Close the gas supply valve when the hob is not being used.

The manufacturer accepts no responsibility for injury to persons or damage to property caused by failure to comply with this procedure. This appliance can only be used for cooking. Any tampering with or modification to the appliance can be a source of danger. Make sure gas distribution systems are as required before installing the appliance. The gas for which the hob is designed is indicated on the label on the bottom of the control box. This appliance is not joined to a device for evacuating products of combustion and must be installed and hooked-up according to current regulations.

13