COMPRESSOR REPLACEMENT
Recommended procedure for compressor replacement
WARNING
RISK OF ELECTRIC SHOCK
Unplug and/or disconnect all electrical power to the unit before performing inspections, maintenances or service.
Failure to do so could result in electric shock, serious injury or death.
1.Be certain to perform all necessary electrical and refrigeration tests to be sure the compressor is actually defective before replacing.
WARNING
HIGH PRESSURE HAZARD
Sealed Refrigeration System contains refrigerant and oil under high pressure.
Proper safety procedures must be followed, and proper protective clothing must be worn when working with refrigerants.
Failure to follow these procedures could result in serious injury or death.
2.Recover all refrigerant from the system though the process tubes. PROPER HANDLING OF
RECOVERED REFRIGERANT ACCORDING TO EPA REGULATIONS IS REQUIRED. Do not use gauge manifold for this purpose if there has been a burnout. You will contaminate your manifold and hoses. Use a Schrader valve adapter and copper tubing for burnout failures.
WARNING
HIGH TEMPERATURES
Extreme care, proper judgment and all safety procedures must be followed when testing, troubleshooting, handling or working around unit while in operation with high temperature components. Wear protective safety aids such as: gloves, clothing etc.
Failure to do so could result in serious burn injury.
NOTICE
FIRE HAZARD
The use of a torch requires extreme care and proper judgment. Follow all safety recommended precautions and protect surrounding areas with fi re proof materials. Have a fi re extinguisher readily available. Failure to follow this notice could result in moderate to serious property damage.
3.After all refrigerant has been recovered, disconnect suction and discharge lines from the compressor and remove compressor. Be certain to have both suction and discharge process tubes open to atmosphere.
4.Carefully pour a small amount of oil from the suction
stub of the defective compressor into a clean container.
5.Using an acid test kit (one shot or conventional kit), test the oil for acid content according to the instructions with the kit.
6.If any evidence of a burnout is found, no matter how slight, the system will need to be cleaned up following proper procedures.
7.Install the replacement compressor.
WARNING
EXPLOSION HAZARD
The use of nitrogen requires a pressure regulator. Follow all safety procedures and wear protective safety clothing etc.
Failure to follow proper safety procedures result in serious injury or death.
8.Pressurize with a combination of
Repeat Step 8 to insure no more leaks are present.
9.Evacuate the system with a good vacuum pump capable of a fi nal vacuum of 200 microns or less. The system should be evacuated through both liquid line and suction line gauge ports. While the unit is being evacuated, seal all openings on the defective compressor. Compressor manufacturers will void warranties on units received not properly sealed. Do not distort the manufacturers tube connections.
CAUTION
FREEZE HAZARD
Proper safety procedures must be followed, and proper protective clothing must be worn when working with liquid refrigerant.
Failure to follow these procedures could result in minor to moderate injury.
10.Recharge the system with the correct amount of refrigerant. The proper refrigerant charge will be found on the unit rating plate. The use of an accurate measuring device, such as a charging cylinder, electronic scales or similar device is necessary.
25
