How to use the remote control (XQ models)
To start unit
1POWER - Press the Power button once. The unit will automatically start in the mode and fan speed it was last left on.
To set mode of operation
2COOL - Press the Cool button to automatically switch the operating mode to COOL.
3FAN ONLY - Press the Fan Only button if you want to run the fan only.
4MoneySaver® - Press the MoneySaver® button to activate the MoneySaver® feature. This feature cycles the fan with the compres- sor so that the fan does not run all the time.
To set the timer
NOTE: You can set the START and STOP times a minimum of one hour apart, and a maximum of 23 hours apart.
9TIMER START - Press Start to view the current start time for cooling. Continue pressing the Start button until you arrive at the start time you desire. The start time for cooling will then be set.
10TIMER STOP - Press the Stop button. Continue pressing the Stop button until you arrive at the stop time you desire. The stop time for cooling will then be set.
11TIMER ON / OFF - Press the On/Off button to activate (light on) or deactivate (light off) the timer. Once the on and off times have been selected, they will remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the Set Hr. function must be reset or the On/Off function will not work.
To adjust temperature setting
5WARMER - Press the Warmer button to raise the temperature setting.
6COOLER - Press the Cooler button to lower the temperature setting.
To adjust fan speed
7FAN SPEED - Press the Fan Speed button to see the current set- ting. Press again to change the fan speed. F1 is the lowest setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is the SMART FAN setting.
To set the hour clock
8SET HOUR CLOCK - Press Set Hr. once to see the current clock setting. Continue pressing the button until you arrive at the current time (Hour only). Minutes are not shown on the display. Make sure that the A.M. / P.M. setting is correct.
Temperature |
|
|
| |
Cooler |
| Warmer | ||
6 |
|
|
| 5 |
Cool |
|
|
| Power |
2 |
|
|
| 1 |
Fan | Fan |
|
| Money |
3 |
|
|
| 4 |
Only | Speed |
| Saver® | |
Timer Operation |
|
| 7 | |
On/O | Start | Stop | Set Hr. | |
11 |
|
|
| 8 |
9 |
|
|
| 10 |
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.
How To Operate The EQ08
Function Control Knob
The left knob is a six position control that allows you to select heat or cool in either low speed or high speed. Plus you can select fan only if you wish.
Thermostat Knob
The right hand knob is the thermostat - turn it clockwise for cooler,
10