NAME OF PARTS
Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3Remote Control Signal Receiver
4Indicator Lamps (Fig. 3)
5OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (see page 17 Auto Restart).
7SWING Indicator Lamp (orange)
8Intake Grille (Fig. 4)
9 Air Filter
0 Air Flow Direction Louver A
(behind Air Flow Direction Louver) B Drain Hose
C Inter
D Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
EPower Supply F Intake Port G Outlet Port H Pipe Unit
I Drain port (bottom)
Fig. 6 Remote Control Unit 
JSLEEP button
KMASTER CONTROL button
LSET TEMP./SET TIME button (
) M Signal Transmitter
N TIMER button
O FAN CONTROL button P START/STOP button
Q AIR FLOW DIRECTION button R SWING LOUVER button
Rear side (Fig. 7)
STIME ADJUST button T ACL button
(located inside battery compartment) U TEST RUN button
●This button is used when installing the unit, and should not be used under nor- mal conditions, as it will cause the air con- ditioner’s thermostat function to operate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the Indoor Unit’s OPERA- TION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air condi- tioner.
VRemote Control Unit Display (Fig. 8) W Transmit Indicator
X Clock Display
Y Operating Mode Display Z Timer Mode Display
[ Fan Speed Display
\ Temperature Set Display ] Timer Set Indicator
` Temperature Set Indicator
