Section III – Chassis Installation
*Check to be sure the wall sleeve, extension (if used), grille, and drain kit are installed properly before chassis installation
1.Remove the weatherboard and center support from the sleeve (if still in place). Be sure an outdoor grille is attached.
1
Wall sleeve
Weatherboard
Center support
NOTE: To avoid breaking the door or hinge pins, do not apply excessive force when installing
2 Pins
Control
Door
Front Panel
3.Remove the two chassis shipping brackets from the ends of the shipping pallet.
IMPORTANT: Use a wall sleeve adapter kit (PXSE) if installing a
Suffocation hazard
Keep bag away from babies and children.
Do NOT use in cribs, beds or playpens. Destroy immediately after opening. This bag is NOT a toy.
Failure to do so can result in personal injury and/or death
2.Remove the front cover contained in a protective plastic bag from chassis. Remove the bag and dispose of it properly.
If the control door is not installed, follow these steps:
•From the front of the cover, slide the right control door pin into the hole on the right side of the front cover. Slide the left door pin into the hole on the left side of the front cover opening and snap it into place.
3
Compressor
Chassis shipping bracket
Shipping pallet
IMPORTANT: When installing a Friedrich
12